Editing 2589: Outlet Denier
Warning: You are not logged in. Your IP address will be publicly visible if you make any edits. If you log in or create an account, your edits will be attributed to your username, along with other benefits.
The edit can be undone.
Please check the comparison below to verify that this is what you want to do, and then save the changes below to finish undoing the edit.
Latest revision | Your text | ||
Line 23: | Line 23: | ||
==Transcript== | ==Transcript== | ||
+ | {{incomplete transcript|Needs clarification}} | ||
:[To the left is a power strip with a rocker switch at the top and five outlets, and a connected wire goes from the top off to the left. To the right is the plug that should go into one of the outlets. A curved wire comes from the right and connects to the end of the connector, which is longer than a normal plug. The prongs are visible underneath where the box ends. But instead of ending there, there is a bar horizontal to the first part, which is longer than the power strip itself. There is a D shaped bar attached to this long bar, centered on the middle of the bar. If it was plugged in, the long bar would cover all the other outlets of the power strip.] | :[To the left is a power strip with a rocker switch at the top and five outlets, and a connected wire goes from the top off to the left. To the right is the plug that should go into one of the outlets. A curved wire comes from the right and connects to the end of the connector, which is longer than a normal plug. The prongs are visible underneath where the box ends. But instead of ending there, there is a bar horizontal to the first part, which is longer than the power strip itself. There is a D shaped bar attached to this long bar, centered on the middle of the bar. If it was plugged in, the long bar would cover all the other outlets of the power strip.] | ||